Comments on: 70mm Dust Shoe Brush, STARVAST CNC Vacuum Brush for Vacuum Cleaner Engraving Machine Dust Cover Work on CNC Router Spindle Motor

By: David H.

David H. — Sat, 11 Jan 2025 08:17:51 +0000

Great value-well made
Bought this to contain The dust at the out feed end of my 24â dual drum sander. It works great. The bush is well made and exactly the right stiffness. Good value!

By: John

John — Sat, 11 Jan 2025 08:17:51 +0000

As expected. NO ISSUES.
Looks good, flexible. I’m sure it will work perfectly for my project.

By: Brett Wright

Brett Wright — Sat, 11 Jan 2025 08:17:51 +0000

Works like it should
Very full brush, I trimmed it some so it wouldnât be pushing back and my Z stepper motor on my cnc machine, works like it should

By: Amazon Customer

Amazon Customer — Sat, 11 Jan 2025 08:17:51 +0000

It doesn’t look like the picture.
OK, it’s built like the picture, but there are a lot of loose bristles, and strings everywhere. But hey, it’s cheap enough so I’ll live with it. I’d give it 5 stars if actually arrived as neat and tidy as the image!

By: Sandman

Sandman — Sat, 11 Jan 2025 08:17:51 +0000

Way too stiff for small Openbuilds CNC router
During the plunge, the brittles would hold up the router and cause it to skip steps. I even tried removing half the brittles, but it did not help. Would probably work on large router table. Quality seemed good.

By: Amber R.

Amber R. — Sat, 11 Jan 2025 08:17:51 +0000

Works great!!!
It fits perfectly!!!

By: Dan

Dan — Sat, 11 Jan 2025 08:17:51 +0000

Very good quality
Used this brush to make my own CNC vacuum shoe. The 4″ was a bit long for my application. But after I cut it down to 3″ its been perfect. Definitely would buy this again.

By: Butch

Butch — Sat, 11 Jan 2025 08:17:51 +0000

Dust Out
I used this to stop the dust from entering my area after I built a container box for the miter saw. I put around an opening made in the back to extend the dust discharge. Works great

By: Tedski

Tedski — Sat, 11 Jan 2025 08:17:51 +0000

Did the job nicely.